Henning Flat Trigger System New Product!

This flat trigger is designed to fit in the frame very tightly. It rotates on a solid pin instead of a roll pin which controls the movement. The Pre- and Over-travel adjustments are highly improved over the factory trigger. You can read the full technical article here. Single Action Only.

For a smoother and lighter trigger pull, try the Huening Rolling Trigger plunger. An old classic from the old P9 days has been re-vived and is particularly beneficial when combined with the Henning Flat Trigger System. I use it in my gun. I will soon also offer lighter trigger plunger springs which will further reduce trigger weight and improve function. We're working hard to make the trigger system as optimal as possible. Stay tuned !

EGW Prepped Hammer New Product!

High quality after market hammer with different angles than factory for a crisper trigger. Only works with EGW sear. The hammer hooks have been cut to 0.012", half cock shortened. Single Action Only.

High quality after market sear which has been prepped. Sear is hardened to Rockwell 55 which will make it last almost forever.. Trigger reset leg has been cut, sear face polished.

There is no surprise that both factory and after market parts have a variance in their tolerances. If you buy an EGW hammer and sear it means you try to achieve the best possible trigger; crisp and light with a short reset. Besides switching to quality hammers and sears, what makes these parts tick is their fit to the frame. If the pins that holds the sear and hammer are smaller than the holes in the parts they are guiding, the sear and hammer cannot rotate consistently. To do it right - replace the sear and hammer pin with high quality 416 stainless, hardened pins to Rockwell 42. These parts will not wear like the factory pins which gradually gets chewed up. All pins are designed to be ever so slightly oversize because there is a variance in the factory parts. On some guns the pins will slip right in, but for the most part the holes will need to be reamed to fit the pin. Ream the hole to size, not the other way around ! Besides tighter tolerances, the hammer pin pin has been designed for easier dis/assembly.

Fits Tanfoglio models. Comes on models such as Gold Team, Limited, Match.

Fits Tanfoglio models. Comes on models such as Stock II

Factory sear. Works with both Single and Double Action Hammers.

The Sear Housing holds the sear in with a sear pin (9.2) and a sear spring (9.3). These parts are not included in the Sear Housing. The Sear Housing is also the Ejector.

Factory spec for all single action Tanfoglio models, like Gold Team, Limited and Match.

"Chrome look" double action trigger with adjustable over-travel.

Factory spec for Tanfoglio Stock, Steel models. Available in either blued or "chrome look" finish.

If you have a double action model or want to convert your single action pistol into a double action, you need to install this interruptor on a factory hammer. Comes as a kit with pin to attach to your double action hammer.

Fits all Tanfoglio pistols. Hot tip: Polishing sides and where the trigger plunger meets the bar improves the trigger feel.

Before you order, make sure you know if you have a small or large frame model pistol. If you are not sure what frame you have, check your mags.

Complete plunger consisting of four minor parts. Plunger sits underneath trigger bar.