The ultimate trigger kit for the EAA Witness - Tanfoglio pistols includes EGW's Hammer and Sear that has been prepped to my specifications, HENNING X-Long Firing Pin and a 13lb Wolff Hammer Spring. The hammer is made from barstock, hooks prepped to 0.012" and the half-cock cut back. The hard sear is hardened to Rockwell 55, reset leg been cut back and sear face polished. It will give you a consistent trigger pull for a long time. The 13lb Wolff Hammer Spring reduces your new nice trigger pull considerably and the X-Long Firing Pin gives you 100% consistent ignition. This kit should be installed by a gunsmith, sear will require a minimum of fitting to thumb safety. For additional lightening of trigger pull, the sear face will need stoning/polishing and reset can be shortened additionally. If you can't find a gunsmith or don't want to do it yourself, you can send the gun to me and I will do the trigger job for you.

EGW's hardened slide stop pin replaces the factory slide stop. If you are running Gram's follower & spring kits, you'll need this slide stop.

EGW makes an after market Firing Pin for the Large Frame that is far superior to the factory firing pin. It is 20% lighter and harder which eliminates shearing.

EGW offers a custom made, carbide sizing dies that are 0.001" smaller in diameter than typical dies. These dies also flair lower than some other sizing dies and size the case further down, which may prevent feed failures from cases bulged near the base as is typical of brass fired in Glock and other loose chambered guns.

A must for the serious competition reloader.